NT1310 unit 5 Essay - 857 Words

Unit 5 assignment 1 and definitions When performing a cable installation, there are a lot of things that you have to put into consideration. First, you want to draw up a plan. Some things that you would want to include in the plan would be: where your telecommunications rooms are located, what is the distance from your leased line to your core router, and what type of cable are you going to be using for your backbone and horizontal lines. The first thing shouldn’t be cost when you are designing a network. You want to think of the safety and how your network will function with different mediums of cable. These things are important because your network has to meet the needs of the company. You also want to make sure you have things in place†¦show more content†¦But of course this is not the most used method to strip cable. It will work if you need it right then. All the things that I have talked about are important because it will help you to make sure you have a plan that covers everything. You not only need to think about cost but safety as well. Make sure you have the right tools for the right job. Also make sure your measurements are correct cause this could also make or break your network plan. Definitions: Wall plate – it is the plastic or metal plate that screws into the wall. It has some sort of connector, usually coax, rj11, rj45, duplex receptacle, or fiber optic. This is where the device plugs into the wall. Connector – a device that joins two pieces of cabling Crossover cable - A crossover cable is a type of twisted pair copper wire cable for LANs (local area network) in which the wires on the cable are crossed over so that the receive signal pins on the RJ-45 connector on one end are connected to the transmit signal pins on the RJ-45 connector on the other end. NIC - A network interface controller (NIC, also known as a network interface card, network adapter, LAN adapter, and by similar terms) is a computer hardware component that connects a computer to a computer network HUB - An Ethernet hub, active hub, network hub, repeater hub, multiport repeater or hub is a device for connecting multiple Ethernet devices together and making them act as a single network segment. Bridge - A device used toShow MoreRelatedUnit 3 Exercise 1 Nt13101332 Words   |  6 Pages| Unit 3. Exercise 1. | | Specifications - Definitions | | Unit 3. Exercise 1. | | Specifications - Definitions | NT1310: physical networking April 15, 2014 Authored by: Nicholas Rapisardi NT1310: physical networking April 15, 2014 Authored by: Nicholas Rapisardi 1. Application (in terms of cabling infrastructure): The application layer is the OSI layer closest to the end user, which means both the OSI application layer and the user interact directly with the